![]() ![]() With a retract distance reduced to 4mm, you get the part on the right in the picture. This can help reduce computer memory resources when rendering large scenes with huge textures. The engine can no longer push it efficiently. Automatically scales textures down so that they are no larger than the values chosen. ![]() Too much shrinkage brings hot material back into the heat-break, the temperature of the heat-break gradually rises and the melting filament gets stuck in the heat-break. ![]() Passed to 6mm of retract, one obtains the central piece. The part on the left was printed with 1.5mm of retract, which was clearly insufficient. Increase the "retract" distance in the slicer. Depending on the tube and filament diameters, and the length of the casing, the motor must pull a certain length of filament through the tube curves before the filament retracts from the heating head. The first impressions with your extruder are not very good, too much extruded material, bridges drawn between different areas during movements where the extrusion should stop.įilament shrinkage is insufficient to compensate for play in the Bowden tube. Check out this video tutorial to learn how to reduce the size of a 3D model by compressing its textures and decimating its vertices. But if you have manually added support you lose that. The extruder in Bowden flows too much or not enough. The only way to save the process only is to remove the the model from the table first. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |